The CG range of piling hammers is designed for driving a variety of bearing piles including steel tube, combi piles, ‘H’ sections and reinforced / pre stressed concrete piles. Operated from piling rig leaders or crane suspended, the CG range has the following important features:

• Total control of hammer stroke and blow rate
• Allows precise matching of energy to suit the pile driving requirements
• Simple fast dolley changing
• Cylinder and dropweight connection with shock absorber, easily accessible
• Economical – Low Hydraulic power requirement • Available with BSP Hydropacks for optimum hammer performance
• Can drive Piles with ultimate load bearing up to 14,500 kN
• Suitable for driving Raked (Batter) Piles

The CX range of piling hammers is designed for driving a wide variety of bearing and sheet piles. Available with legs and inserts or pile sleeves for use freely suspended, or with back guides for operating from a piling mast, the CX range have the following important features:

• Total control of hammer stroke and blow rate
• Allows precise matching of energy to suit the pile driving requirements
• Highly efficient hydraulic system gives low energy loss and low running cost
• Simple, fast dolley changing
• Cylinder and dropweight connection with shock absorber, easily accessible
• Cage and dropweight design gives short overall hammer length
• Available with BSP Hydropacks for optimum hammer performance
• Can be operated directly from Hydraulic crane or excavator base
• Can drive piles with ultimate load bearing up to 6000 kN
• Suitable for driving Raked (Batter) Piles

The BSP DX-RT range of hydraulic piling hammers have been developed to meet the needs of Railway Infrastructure projects.  It’s design allows quick and simple mounting onto the stick of a wide range of  small Road-Rail excavators.

The hammer mounts directly to the excavators bucket linkage and the attachment allows for fast erection from horizontal transport position to a vertical plumb working position.  Further side plumbing adjustment is possible to give a hammer position ±5° of vertical to deal with the cant of rail lines.

During piling the hammer is guided or crowded in the vertical position by the attachment mechanism.

A typical high production piling train will use an excavator mounted side grip vibrator to place, pitch and part drive the pile.  The powerful DX-RT pile driver with its rapid blow rate is then used to drive the pile to the desired level, quickly and efficiently.